JLG 1100SJP Operator Manual - Manual (Page 34)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-2 – JLG Lift – 3121255
Ground Control Station
NOTE: The Function Enable switch must be held
down in order to operate boom and platform
functions.
NOTE: The Boom Control system will only allow the boom to
operate in Automatic mode from the Ground Control Sta-
tion.
(See Figure 3-1., Ground Control Station - 1100S and Figure 3-2.,
Ground Control Station - 1100SJP)
1. Indicator Panel
The LED Indicator Panel contains indicator lights that
signal problem conditions or functions operating during
machine operation.
2. Boom Control System Test Button
The push button is used to test the boom control system
and confirm that it is working properly.
3. Telescope Control
Provides extension and retraction of the boom.
4. Swing Control
Provides 360 degrees continuous turntable rotation.
5. Lift Control
Provides raising and lowering of the boom.
NOTE: With PLATFORM/GROUND SELECT switch in the center
position, power is shut off to controls at both operating
stations.
6. Platform/Ground Select Switch
A three position, key operated switch supplies power to
the platform control console when positioned to PLAT-
FORM. With the switch key turned to the GROUND posi-
tion, power is shut off to platform and only ground
controls are operable.
7. Hourmeter
Registers the amount of time the machine has been in
use, with engine running. By connecting into the oil
pressure circuit of the engine, only engine run hours are
recorded. The hourmeter registers up to 9,999.9 hours
and cannot be reset.