JLG 1100SJP Operator Manual - Manual (Page 44)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-12 – JLG Lift – 3121255
4. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illumi-
nate when the drive function is selected. Push and
release the switch, and within 3 seconds move the
Drive/Steer control to activate drive or steer. Before driv-
ing, locate the black/white orientation arrows on both
the chassis and the platform controls. Move the drive
controls in a direction matching the directional arrows.
NOTE: To operate the Drive Joystick, pull up on the locking ring
below the handle.
NOTE: The DRIVE control levers are spring-loaded and will auto-
matically return to neutral (OFF) position when released.
5. Drive/Steer
The DRIVE joystick provides for driving either forward or
backward. The controller is ‘ramped’ to allow variable
drive speed.
Steering is controlled by a thumb operated switch on
top of the joystick.
6. Main Telescope
This control allows extension and retraction of the main
boom.
7. Lights (If Equipped)
This switch operates accessory light packages if the
machine is so equipped.
8. Jib Lift
Push forward to lift up, pull back to lift down. Variable lift
speed is using the Function Speed Control.
9. Soft Touch Override Switch (If equipped)(1100S Only)
This switch enables the functions that were cut out by
the Soft Touch system to operate again at creep speed,
allowing the operator to move the platform away from
the obstacle that caused the shutdown situation.