JLG 1100SJP Operator Manual - Manual (Page 29)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3121255 – JLG Lift – 2-9
General
Begin the "Walk-Around Inspection" at Item 1, as noted on
the diagram. Continue checking each item in sequence
for the conditions listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF.
DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN
CORRECTED.
INSPECTION NOTE: On all components, make sure there
are no loose or missing parts, that they are securely fas-
tened, and no visible damage, leaks or excessive wear
exists in addition to any other criteria mentioned.
1. Platform Assembly and Gate - Footswitch works
properly, not modified, disabled or blocked. Drop bar
operates smoothly. Latch and hinges in working con-
dition (If equipped).
2. Platform & Ground Control Consoles - Switches
and levers return to neutral, decals/placards secure
and legible, control markings legible.
3. Console Cover - Detent functions properly, smooth
operation.
4. Boom Sections/Turntable - See Inspection Note.
5. Swing Drive - No evidence of damage.
6. Wheel/Tire Assemblies - Properly secured, no miss-
ing lug nuts. Inspect for worn tread, cuts, tears or
other discrepancies. Inspect wheels for damage and
corrosion.
7. Drive Motor, Brake, and Hub - No evidence of leak-
age.
8. Hood Assemblies - See Inspection Note.
9. Auxiliary Hydraulic Pump - See Inspection Note.
10. All Hydraulic Cylinders - No visible damage; pivot
pins and hydraulic hoses undamaged, not leaking.
11. Turntable Bearing - Evidence of proper lubrication.
No evidence of loose bolts or looseness between
bearing and machine.
Figure 2-3. Daily Walk-Around Inspection - Sheet 2 of 3