JLG 3969electric Operator Manual User Manual
Page 21
SECTION 2 - PREPARATION AND INSPECTION
3120880
– JLG Sizzor –
2-7
Figure 2-2. Lubrication Diagram
TO AVOID PERSONAL INJURY, USE SAFETY PROP FOR ALL
MAINTENANCE REQUIRING PLATFORM TO BE ELEVATED
NOTE: Be sure to lubricate like items on each side of the
machine
Recommended lubricating intervals are based on
machine operations under normal conditions. For
machines used in multi-shift operations and/or
exposed to hostile environments or conditions,
lubricating frequencies must be increased accord-
ingly.
Table 2-1. Lubrication Chart
INDEX
NUMBER
COMPONENT
NO/TYPE LUBE
POINTS
LUBE/METHOD
INTERVAL HOURS
COMMENTS
1
Hydraulic Oil
Fill Cap/Drain Plug
HO - Kendall Hyken
052
8/800
Check oil every 8 hours of operation
Change oil every 800 hours of operation
2
Torque Hub
Fill Plug/Half full
EPGL - SAE 90
2000
Check oil level at side plug on hub
3
Wheel Bearings
Front Wheels
Repack
800
2 years
4
Sliding Wear Pads
8 Wear Pads
Brush
50
N/A
5
Hydraulic Filter Element
(not shown)
N/A
Replaceable Element
40/250
Replace filter element after first 40 hours of operation
then every 250 hour thereafter
KEY TO LUBRICANTS:
HO - Hydraulic Oil - Kendall Hyken 052
EPGL - Extreme Pressure Gear Lube