JLG G5-18A Service Manual - Manual (Page 88)

Engine
7-10 G5-18A, 2505H, 25.5
7.6 AIR CLEANER ASSEMBLY
Note: Refer to the machine Operation & Safety Manual
for the correct element change procedure.
7.6.1 Air Cleaner Assembly Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake, and shut the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel, stating that the machine
should not be operated.
3. Open the engine cover. Allow the system fluids to
cool.
4. Properly disconnect the battery.
5. Loosen the clamp (3) securing the air intake elbow to
the air cleaner assembly. Pull the air intake elbow off
the air cleaner.
6. Remove the hardware securing the air cleaner to the
air cleaner mounting plate (4). Remove the air
cleaner assembly (5).
7.6.2 Air Cleaner Assembly Installation
1. Install the air cleaner assembly (5) to the air cleaner
mounting plate with the previously used hardware
(4). Hand torque mounting bolts to 10-12 lb-ft
(13,5-16,3 Nm).
2. Place the loosened clamp (3) over the air intake
elbow and install elbow on the air cleaner assembly.
3. Adjust and tighten clamps before starting the
machine.
4. Properly connect the battery.
5. Close and secure the engine cover.
6. Remove the Do Not Operate Tags from both the
ignition key and the steering wheel.
CAUTION
NEVER run the engine with only the inner safety
element installed.
MY9010
5
3
4