JLG 80HX_HX+6 Operator Manual - Manual (Page 24)

SECTION 2 - PREPARATION AND INSPECTION
3120890 – JLG Lift – 2-7
GENERAL
NOTE: Begin the “Walk-Around Inspection” at Item 1, as
noted on the diagram. Continue to the right (counter-
clockwise viewed from top) checking each item in
sequence for the conditions listed in the “Walk-
Around Inspection Checklist”.
TO AVOID INJURY, DO NOT OPERATE A MACHINE UNTIL ALL
MALFUNCTIONS HAVE BEEN CORRECTED. USE OF A MALFUNC-
TIONING MACHINE IS A SAFETY VIOLATION. TO AVOID POSSI-
BLE INJURY, BE SURE MACHINE POWER IS “OFF” DURING
WALK-AROUND INSPECTION.
NOTE: Do not overlook visual inspection of chassis under-
side. Checking this area often results in discovery of
conditions which could cause extensive machine
damage.
1. Platform Assembly - No loose or missing parts, no
visible damage. Lock bolts in place. Footswitch in
good working order, not modified, disabled or
blocked. Check area of fly boom nose section
above and under platform slave level cylinder for
accumulation of foreign material. Remove any for-
eign material present.
2. Platform Control Console - Switches and levers
return to neutral and are properly secured, no loose
or missing parts, no visible damage, decals/plac-
ards secure and legible, control marking legible.
3. Rotator - Properly secured, no visible damage, no
evidence of leakage.
4. Rotator and Motor - Properly secured, no visible
damage, no evidence of leakage.
5. Slave Leveling Cylinder, Extend-A-Reach - Prop-
erly secured, no visible damage, no evidence of
leakage. (If equipped on Extend-A-Reach)
6. Extend-A-Reach Lift Cylinder - Properly secured,
no visible damage, or signs of leakage, evidence of
proper lubrication. (If equipped on Extend-A-Reach)
7. Extend-A-Reach Pivot - No loose, damaged, or
missing parts, evidence of proper lubrication. (If
equipped on Extend-A-Reach)
8. Hose and Cable Guards/Clamps - Properly
secured, no visible damage.
9. Power Track - No loose, damaged or missing parts,
no visible damage.
10. Steer Cylinder Assembly, Right Rear - Properly
secured, no visible damage or signs of leakage. (4
Wheel Steer)
11. Tie Rod and Steering Linkage - No loose or miss-
ing parts, no visible damage. Tie rod end studs
locked. (4 Wheel Steer)
12. Drive Motor and Brake, Right Rear - No visible
damage, no evidence of leakage.
13. Spindle, Right Rear - No loose or missing parts, no
visible damage, evidence of proper lubrication. (4
Wheel Steer)
14. Drive Hub, Right Rear - No visible damage, no evi-
dence of leakage.
15. Wheel/Tire Assembly, Right Rear - Properly
secured, no loose or missing lug nuts, no visible
damage.
16. Turntable Bearing and Pinion - No loose or miss-
ing hardware; no visible damage, evidence of
proper lubrication. No evidence of loose bolts or
looseness between bearing and structure.
17. Swing Drive Motor and Brake - No visible damage,
no evidence of leakage.
18. Fuel Supply - Fuel filler cap secure. Tank - no visible
damage; no evidence of leaks.
19. Extend-A-Reach Control valves (Tank Compart-
ment) No visible damage, no evidence of leakage,
no unsupported wires or hoses, no damaged wires.
Figure 2-3. Daily Walk-Around Inspection - Sheet 2 of 4