JLG E300 Operator Manual - Manual (Page 33)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121214 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: This machines is equipped with control panels that use
symbols to indicate control functions. On ANSI machines,
refer to decal located on the control box guard in front of
the control box or by the ground controls for these sym-
bols and the corresponding functions.
Ground Control Station
See Figure 3-1., Figure 3-2., and Figure 3-3.
NOTE: When machine is shut down the Platform/Ground Select
switch and Emergency Stop must be positioned to OFF.
NOTE: When Power/Emergency Stop Switch is in the on position
and motor is not running, an alarm will sound, indicating
power is on.
NOTE: If equipped, the Function Enable switch must be held
down in order to operate Boom Telescope, Lower Lift,
Swing, Main Lift, Jib Lift, Platform Level Override, and
Platform Rotate functions.
1. Battery Status
Three LED lights indicate charge status of battery.
Green; indicates 100% charged. Yellow; indicates
charger on. Red; indicates abnormal battery condition.
2. Jib Swing (E300 AJP only)
A jib swing joystick controls raising and lowering and
swinging left and right of platform.