JLG E300 Operator Manual - Manual (Page 43)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121214 – JLG Lift – 3-11
Platform Control Indicator Panel
NOTE: The platform control indicator panel uses different shaped
symbols to alert the operator to different types of opera-
tional situations that could arise. The meaning of those
symbols are explained below.
1. Tilt Alarm Warning Light and Alarm
This orange illuminator indicates that the chassis is on a
slope. An alarm will also sound when the chassis is on a
slope and the boom is above horizontal. If lit when boom
is raised or extended, retract and lower to below hori-
zontal then reposition machine so that it is level before
continuing operation. If the boom is above horizontal
and the machine is on a slope, the tilt alarm warning
light will illuminate and an alarm will sound and CREEP
is automatically activated.
IF TILT WARNING LIGHT IS ILLUMINATED WHEN BOOM IS RAISED OR
EXTENDED, RETRACT AND LOWER TO BELOW HORIZONTAL THEN
REPOSITION MACHINE SO THAT IT IS LEVEL BEFORE EXTENDING
BOOM OR RAISING BOOM ABOVE HORIZONTAL.
Indicates a potentially hazardous situation, which
if not corrected, could result in serious injury or
death. This indicator will be red.
Indicates an abnormal operating condition,
which if not corrected, may result in machine
interruption or damage. This indicator will be yel-
low.
Indicates important information regarding the
operating condition, i.e. procedures essential for
safe operation. This indicator will be green with
the exception of the capacity indicator which will
be green or yellow depending upon platform
position.
Tilt Angle Market
3° CE & Australia
5° ANSI & Japan