JLG G6-42A Service Manual - Manual (Page 83)

4-9 G6-42A, G9-43A, G10-43A
Cab and Covers
e. Push the roller switch (13) down to activate the
tilt up function. The attachment should TILT UP.
f. Push the roller switch (13) up to activate the tilt
down function. The attachment should TILT
DOWN.
g. Squeeze and release trigger (14)
(back side of joystick) once to deactivate the
Clutch Lock and have the transmission
disengage while depressing the service brake.
Quickly squeeze and release the trigger twice to
activate the Clutch Lock and keep transmission
engaged while depressing the service brake.
Note: Check the controls of the auxiliary attachments.
See the appropriate Operation & Safety Manual for an
approved list of attachments and control instructions.
6. Close and secure the engine cover.
7. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
4.3.5 Frame Level, Attachment Tilt,
Auxiliary Hydraulics and Outriggers
(G10-43A) Joysticks
a. Joystick Removal
1. Park the machine on a firm, level surface, level the
machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake and turn the
engine OFF.
2. Place a Do Not Operate Tag on both the ignition key
switch and steering wheel.
3. Properly disconnect the battery.
4. Remove the knob on the end of the joystick (9).
5. Remove the screws (10) securing the dash panel to
the cab. Remove the dash panel.
6. Remove any hardware securing the joystick to the
cab.
7. Label, disconnect and cap the hydraulic fittings
attached to the joystick.
8. Remove the joystick from the cab.
b. Joystick Installation
1. Uncap and connect the previously labeled hydraulic
hoses to their appropriate locations.
2. Install the bolts securing the joystick to the cab.
3. Install the dash panel to its original position with the
previously used hardware.
4. Install the joystick knob.
5. Properly connect the battery.
6. Test the joystick for proper functions.
Auxiliary Hydraulic Joystick
Check the controls of the auxiliary attachments. See
the appropriate Operation & Safety Manual for an
approved list of attachments and control instructions.
7. Close and secure the engine cover.
8. Remove the Do Not Operate Tags from both the
ignition key switch and the steering wheel.
4.3.6 Windshield Wiper Assembly
Refer to Section 9.9, “Window Wiper/Washer Windshield
Wiper Motor,” for removal and installation information.