2 operator cab, 1 cab safety, 2 serial number decal – JLG G6-42A Service Manual User Manual

Page 79: 3 cab components, 1 steering column and orbitrol valve, Operator cab, Cab components, Cab safety, Serial number decal, Steering column and orbitrol valve

Advertising
background image

4-5

G6-42A, G9-43A, G10-43A

Cab and Covers

4.2

OPERATOR CAB

4.2.1

Cab Safety

4.2.2

Serial Number Decal

The cab serial number decal is located on the left side of
the cab, behind the seat. Information specified on the
serial number plate includes the cab model number, the
cab serial number and other data. Write this information
down in a convenient location to use in cab
correspondence.

4.3

CAB COMPONENTS

4.3.1

Steering Column and Orbitrol Valve

a. Orbitrol Valve Removal

1. Park the machine on a firm, level surface, level the

machine, fully retract the boom, lower the boom,
place the travel select lever in the (N) NEUTRAL
position, engage the parking brake and turn the
engine OFF.

2. Place a Do Not Operate Tag on both the ignition key

switch and the steering wheel.

3. Open the engine cover. Allow the system fluids to

cool.

4. Properly disconnect the battery.

Note: It may be necessary to remove the main dash
panel to gain access to the appropriate hydraulic hoses.
Refer to Section 9.12.1, “Analog Gauges.”

5. Label, disconnect and cap the four hoses from the

side of the steering valve (1). Cap the fittings on the
steering valve. Label, disconnect and plug the load
sense hose at the front of the steering valve. Cap the
fitting on the steering valve.

WARNING

DO NOT service the machine without following all
safety precautions as outlined in Section 1, “Safety
Practices,” o
f this manual.

WARNING

The protection offered by this ROPS/FOPS will be
impaired if subjected to any modification or structural
damage, at which time replacement is necessary.
ROPS/FOPS must be properly installed using
fasteners of correct size and grade, and torqued to
their specified value.

WARNING

DO NOT weld, grind, drill, repair or modify the cab in
any way. Any modification or damage to cab structural
components requires cab replacement. Refer to the
Operation & Safety Manual.

To help ensure optimum safety, protection and
performance, replace the cab if it is damaged. Refer to
the appropriate parts manual for ordering information.

MY0120

1

2

3

4

Advertising
This manual is related to the following products: