JLG 3246E2 Operator Manual - Manual (Page 15)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3120854 – JLG Lift – 2-3
Pre-Start Inspection
The Pre-Start Inspection should include each of the follow-
ing:
1. Cleanliness – Check all surfaces for leakage (oil,
fuel, or battery fluid) or foreign objects. Report any
leakage to the proper maintenance personnel.
2. Decals and Placards – Check all for cleanliness
and legibility. Make sure none of the decals and
placards are missing. Make sure all illegible decals
and placards are cleaned or replaced.
3. Operators and Safety Manuals – Make sure a copy
of the Operator and Safety Manual, EMI Safety Man-
ual (Domestic only), and ANSI Manual of Responsi-
bilities (Domestic only) is enclosed in the weather
resistant storage container.
4. “Walk-Around” Inspection – Refer to Figures 1 and
2.
5. Battery – Charge as required.
6. Fuel (Combustion Engine Powered Machines) –
Add the proper fuel as necessary.
7. Hydraulic Oil – Check the hydraulic oil level. Ensure
hydraulic oil is added as required.
8. Function Check – Once the “Walk-Around” Inspec-
tion is complete, perform a functional check of all
systems in an area free of overhead and ground
level obstructions. Refer to Section 4 for more spe-
cific instructions.
IF THE MACHINE DOES NOT OPERATE PROPERLY, TURN OFF
THE MACHINE IMMEDIATELY! REPORT THE PROBLEM TO THE
PROPER MAINTENANCE PERSONNEL. DO NOT OPERATE THE
MACHINE UNTIL IT IS DECLARED SAFE FOR OPERATION.
Function Check
Perform the Function Check as follows:
1. From the ground control panel with no load in the
platform:
a. Check that all guards protecting the switches or
locks are in place;
b. Operate all functions and check all limiting and
cut-out switches; See Table 2-2, Maximum Cut-
out Height
c. Check auxiliary power (or manual descent);
d. Ensure that all machine functions are disabled
when the Emergency Stop Button is activated.
2. From the platform control console:
a. Ensure that the control console is firmly secured
in the proper location;
b. Check that all guards protecting the switches or
locks are in place;
c. Operate all functions and check all limiting and
cut-out switches;
d. Ensure that all machine functions are disabled
when the Emergency Stop Button is pushed in.
3. With the platform in the transport (stowed) position:
a. Drive the machine on a grade, not to exceed the
rated gradeability, and stop to ensure the brakes
hold;
Check the tilt sensor alarm to ensure proper operation.
Table 2-2. Maximum Cutout Height
Model
High Drive Cutout
(Maximum Height)
Drive Cutout
1932E2 2.6 m N/A
2032E2 2.1 m N/A
2632E2
(Australian Only)
2.9 m N/A
2632E2/2646E2 2.6 m N/A
3246E2 2.8 m N/A