JLG T500J Operator Manual - Manual (Page 64)

SECTION 5 - MACHINE OPERATION
5-10 – JLG Lift – 3121197
5.7 JIB LIFT
1. To raise the jib select the Jib Control on the select switch,
squeeze the enable switch and then move the controller to
the right.
2. To lower the jib select the Jib Control on the select switch,
squeeze the enable switch and then move the controller to
the left.
5.8 USER FAULT CODES
A single digit fault code blinks on the Platform and the Ground
control panel to signal the operator of a procedure fault. Refer to
Table 5-1, User Fault Codes.
Table 5-1. User Fault Codes
Code Message
0 Chassis Tilt Sensor Out Of Range
Running At Creep - Material Hook Mode
1 Function Locked Out - Joystick Not Centered At Startup
Function Locked Out - Trigger Permanently Closed
Function Problem - Engine Choke Permanently Selected
Function Problem - Engine Start Permanently Selected
Function Problem - Jib Down Permanently Selected
Function Problem - Jib Up Permanently Selected
Function Problem - Level Down Permanently Selected
Function Problem - Level Up Permanently Selected
Function Problem - Lift Down Permanently Selected
Function Problem - Lift Up Permanently Selected
Function Problem - Outrigger Set Permanently Selected
Function Problem - Outrigger Stow Permanently Selected
Function Problem - Swing Left Permanently Selected
Function Problem - Swing Right Permanently Selected
Function Problem - Telescope In Permanently Selected
Function Problem - Telescope Out Permanently Selected
Joystick Moved But Trigger Switch Open
Trigger Closed Too Long While In Neutral