JLG 110HX ANSI Service Manual - Manual (Page 76)

SECTION 2 - PROCEDURES
2-52 – JLG Lift – 3120636
6. Place input shaft into spindle counterbore of hub/
spindle assembly. The action of the disengaged
spring should be checked at this time.
7. Slide thrust spacer (18) onto input shaft.
BEWARE OF SHARP EDGES OF COUNTERBORE WHILE SEATING
THIS O-RING.
8. Place o-ring (14) into counterbore of hub/spindle
assembly. Use grease or petroleum jelly to hold o-
ring in place.
9. Assemble carrier assembly (22) as follows:
a. Press bearing cups (28) into both ends of cluster
gear (27) with large inside diameter facing out.
Use an arbor type press with an adapter tool.
b. Place planet shaft (23) on a flat surface with
large diameter down. Place one bearing cone
(29) over shaft and against shoulder. This should
be a slip fit.
c. Place cluster gear over planet shaft and onto
bearing cone, with large gear on top.