JLG 15VPSP Service Manual - Manual (Page 14)

SECTION 1 - SPECIFICATIONS
1-2 – JLG Lift – 3120797
1.1 CAPACITIES
System Voltage
All VP Models –24 Volt DC (2 - 12 volt DC batteries)
Hydraulic Oil Reservoir
All VP Models – 5 qts. U.S. (4.7 ltr.)
1.2 COMPONENT DATA
Hydraulic Pump/Pump Motor Assembly
Pump Motor - 24 Volt DC motor
Pump Displacement –
15VPSP – .098 cu. in./rev. (1.6cc/rev.)
Pump Output (Max.) –
15VPSP - 1.20 gpm @ 2200 psi
Hydraulic System Pressure Setting –
15VPSP - 1000 psi (68.95 bar)
Rear Wheel Drive Motors
Drive Motors -
24 Volt DC w/perm. magnet
Right angle gear
Maintenance free sealed gear
Brake shaft and drive shaft,Integral to Motor
Parking Brake (must be released for pushing)
Batteries/Battery Charger
Batteries (2) – 12 Volt / 100 Amp Hour –
Deep CycleMarine - RV
Battery Charger –
U.S.A.. - 120 Volt A.C. / 60 Hz input
24 volt, 10 amp output - with 2 amp finish
Reset Circuit Breaker
Automatic Charge Circuit
Plug Interlock Circuit
1.3 PERFORMANCE DATA
Platform Capacity
15VPSP –500 lbs. (230 kg) (250 lb. Front/250 lb. Rear)
Platform Size
15VPSP – 28 in. width x 48 in. length (71 cm) x (122 cm)
Machine Height (In Stowed Position)
15VPSP - 82 in. (2.08m) height
Machine Weight
15VPSP - 2,190 lb. (995 kg) (See Table 1. below)
Base Footprint
15VPSP - 32 in. (81 cm) width
52.5 in. (133 cm) length
Max. Platform Height (mast extended)
15VPSP –15 ft.(4.5m)
Platform Working Height (average)
15VPSP –21 ft.(6.4m)
Machine Drive Speed (max.)*
Plat. Lowered - 2 mph (3.22 kph)
Plat. Elevated - 0.5 mph (.81 kph)
(reduced by limit switch)
* Variable to maximum with speed cut back.
Amperage Draw (average)
Lift - 12 amps
Drive - 20 amps
1.4 TORQUE REQUIREMENTS
When maintenance becomes necessary or a fastener has
loosened, refer to the Torque Chart, Figure 1-3 to deter-
mine proper torque value.
Table 1-1.
Machine GVW and Wheel Loads
VP MODEL CONFIG. GVW (no load)
DRIVE WHEEL
(ea) w/rated load
CASTER
(ea) w/rated load
15VPSP ANSI (U.S.) 2,190 lb. (995 kg) 1090 lb. (484 kg) 1090 lb. (484 kg)