JLG 660SJ Service Manual User Manual
Page 55
Advertising
SECTION 3 - CHASSIS & TURNTABLE
3120840
– JLG Lift –
3-5
d. Place washer (31), spring (32), and washer (31),
in that order, onto input shaft.
e. Install retaining ring into input shaft groove to
secure spacers and spring to shaft.
Assembly
1.
Using a suitable press, press new bearing cups (3,
5), with large inside diameters facing out, into hub
(7) counter bores.
2.
Place bearing cone (4) into bearing cup (3) in small
end of hub.
3.
Press new seal (2) into hub counter bore with flat
metal side facing in. Use a flat object to ensure that
seal is pressed evenly and is flush with hub face.
4.
Lower hub onto spindle (1) with large open end up.
Advertising
This manual is related to the following products: