JLG Triple-L Operator Manual - Manual (Page 39)

SECTION 3 - ACCESSORIES
3121224 – Triple-L-Trailer – 3-3
3.2 SCISSOR LIFT CHOCKS (IF EQUIPPED)
The scissor lift chocks may be pre-installed by the factory
in certain trailer models to accommodate certain lifts man-
ufactured by JLG Industries, Inc. (JLG). The Model UT49
or Model 449 are designed to haul a JLG Model 1932E2
Scissor LIft.
The scissor lift chocks are designed to properly position a
JLG scissor lift within the trailer in order to achieve the
proper tongue weight. The chocks are mounted to the
trailer floor and provide a means of positioning the scissor
lift in the left/right and front/rear directions.
THE SCISSOR LIFT CHOCKS ARE INTENDED FOR USE ONLY
FOR SPECIFIED SCISSOR LIFTS THAT ARE MANUFACTURED BY
JLG INDUSTRIES INC.
NOTE: When unloading, the trailer deck must be fully low-
ered onto the ground. The means of securing the
scissor lift must be removed and the scissor lift must
be carefully driven off the trailer deck.
AT SCISSOR LIFT REAR:
TIE DOWN EACH SIDE
TO SCISSOR LIFT LUG.
AT SCISSOR LIFT FRONT:
SECURE TO TRAILER.
Figure 3-2. Tie Down Attach Points