Hydraulic pump/motor, Hydraulic schematic -5, Motor/pump amperage draw (no load in trailer) -5 – JLG Triple-L Operator Manual User Manual

Page 45

Advertising
background image

SECTION 4 - SERVICE AND MAINTENANCE

3121224

– Triple-L-Trailer –

4-5

Hydraulic Pump/Motor

This unitized motor/pump package should be inspected
periodically for any fluid leaks and tank oil level.

Specifications:

Motor - 12 Volts

Tank Capacity - 3 Quarts

Pressure Relief Setting - 1900 psi

Displacement - 0.138 in^3/rev

Full Tank Level - 1" below fill cap when trailer deck is low-
ered.

Fluid Type - DEXTRON II ATF (automatic transmission
fluid).

BATTERY

TO CYLINDER PORT

(ROD END)

UP

DOWN

Figure 4-3. Hydraulic Schematic

Table 4-2. Motor/Pump Amperage Draw

(No Load in Trailer)

PSI

Pump Motor

Amperage Draw

Pump GPM

Flow Rate

At Start up

100 Amps

3.5 GPM

1000 PSI

160 Amps

2 GPM

1900 to 2000 PSI or
at Relief

225 Amps

1.25 GPM

NOTE: You should get approximately 3 to 4 load deck

cycles out of a single charge of the battery. This
will vary depending on deck load.

Advertising