JLG 45e Operator Manual - Manual (Page 59)

SECTION 5 - OPTIONAL EQUIPMENT
3120860 – JLG Lift – 5-1
SECTION 5. OPTIONAL EQUIPMENT
WHEN ADDING AN ELECTRICAL OR ELECTRONIC OPTION TO
THE MACHINE, DO NOT GROUND THE DEVICE TO THE MACHINE
CHASSIS. AN ELECTRICAL OR ELECTRONIC DEVICE THAT IS
GROUNDED TO THE CHASSIS IS SEEN BY THE SEVCON AS A
SHORT CIRCUIT AND WILL CAUSE A FAULT CODE TO APPEAR.
GROUND ALL ELECTRICAL OR ELECTRONIC DEVICES TO THE
APPROPRIATE TERMINAL OF THE SEVCON CONTROLLER.
5.1 MOTION ALARM.
A motion alarm horn provides an audible warning when
the platform controls are selected at the PLATFORM/
GROUND SELECT switch, the EMERGENCY STOP switch
is ON, and the footswitch is depressed. The alarm warns
personnel in the jobsite area to avoid the operating
machine.
5.2 FOAM FILLED TIRES.
Eliminates flats by filling tires with polyurethane foam. For
use where sharp objects are frequently encountered on
operating surface of jobsite.
5.3 NON-MARKING TIRES.
For indoor use, these tires are made from a special com-
pound that, unlike regular tires, will not leave black skid
marks on floors and other surfaces.
5.4 ROTATING BEACON.
An amber rotating beacon may be installed on the
machine hood, and is activated whenever platform con-
trols are selected at the PLATFORM/GROUND SELECT
switch. When activated, the light provides a visual warning
of the machine’s operation.
5.5 TILT ALARM.
An audible warning horn that will sound when the
machine is out of level five degrees in any direction with
the boom raised above horizontal.
5.6 WHEEL COVERS.
Provide protection for wheels and wheel bearings from
dirt, grease, mud, rocks, etc.
5.7 BATTERY PACKS.
Spare battery packs are available to enable the operator
to remove battery packs for charging and replace them
with fresh battery packs to keep machine operating with
minimal down time. Battery packs are interchangeable
and include applicable cables and connectors for “plug-
in” use.
5.8 PLATFORM LIGHTS.
Platform lights may be installed on the machine platform
rails, to provide more lighting for the operator.
5.9 CONTROL CONSOLE COVER.
The control console cover is a one piece clear acrylic
cover which attaches to the platform rails over the control
console. The cover, when in position, will protect the entire
platform control console and the control handle on the
right side of the console.
5.10 CYLINDER BELLOWS.
A one piece accordion shaped rubber bellows may be
attached to the rod end of the cylinder barrel and the cyl-
inder rod as close to the rod attach bushing as possible.
The bellows affords protection to the cylinder rod in either
the extended or retracted position. The bellows are
installed on the lift cylinders, slave cylinder, master cylin-
der, and steer cylinder.
5.11 STEEL HOOD COVERS. (30 ELECTRIC)
The steel covers are positioned over the hood and battery
box lids to protect the Fiberglas hood and battery box lids
from damage.
5.12 WORK PLATFORM. (35/40/N40/45
ELECTRIC)
These machines are available with a 26 in. x 60 in. (.66
x1.52M) size platform.
5.13 SIMULTANEOUS DRIVE / LIFT / STEER.
(N40/40/45 ELECTRIC)
Provides for machines with multifunction performance
simultaneously.