JLG 9MP Operator Manual - Manual (Page 26)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-8 – JLG Lift – 3121162
3.7 BATTERY CHARGING
The 9MP machine is equipped with an 120/240V select-
able AC voltage input/12V - 20Amp DC voltage ouput bat-
tery charger. The charger will automatically terminate
charging when the batteries reach full capacity.
The OEM battery, located under the rear cover with the
charger, is a 12V - 100 O.A.H. - type 2/marine combination
- valve regulated - maintenance free battery.
To Charge Batteries
1. Place machine in a well ventilated area near an AC
voltage electrical outlet.
2. Check the AC voltage selector switch on front of the
battery charger is set to correct local AC voltage
(120 or 240VAC).
3. Plug a heavy duty AC extension cord into the
Charger AC Input cord at the right rear of the
machine, or if equipped, plug in cord from optional
cord reel mounted on base frame.
1. Battery Charger 2. Machine Rear Cover
Figure 3-5. Battery Charger Location.
Battery Charger Front Panel Controls and Indicators
1. Charging Status LED’s 4. AC Input Voltage Selector
2. 120V/8 Amp Breaker
5. Battery Discharge Indicator
3. 240V/8 Amp Breaker
1
2
1
2 3
4 5
Charger AC Input Location
1. Charger AC Input Cord 2. Cord Reel - Option
1
2