JLG 266 LoPro Operator Manual - Manual (Page 31)

Section 2 - Pre-Operation And Inspection
2-7 3126023
4. Mirror (266 LoPro) (Italian, If Equipped) - Clean and undamaged.
5. Mirror - Clean and undamaged.
6. Cab and Electrical -
• General appearance; no visible damage.
• Frame level indicator(s) and window glass undamaged and clean.
• Gauges, switches, joystick, foot controls and horn operational.
• Check seat belt for damage, replace belt if frayed or cut webbing, damaged
buckles or loose mounting hardware.
7. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
8. Rear Axle - Steer cylinders undamaged, not leaking; pivot pins secure;
hydraulic hoses undamaged, not leaking.
9. Main Control Valve - See inspection note.
10. Mirror (266 LoPro) - Clean and undamaged.
11. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
12. Engine Compartment -
• Drive belts, check condition and replace as required.
• Air cleaner element condition indicator, check for clogged condition. Replace
element as required.
• Check and clean Pre-Cleaner as required.
• Battery cables tight, no visible damage or corrosion.
• Engine cover properly secured and latched.
13. Mirror (266, 266 LoPro) - Clean and undamaged.
14. Wheel/Tire Assembly - Properly inflated and secured; no loose or missing lug
nuts. Inspect for worn tread, cuts, tears or other discrepancies.
15. Attachment - Properly installed, see “Attachment Installation” on page 5-7.