JLG 266 LoPro Operator Manual - Manual (Page 117)

Section 7 - Lubrication and Maintenance
7-13 3126023
Hydraulic Oil
A. Hydraulic Oil Level Check
1. Be sure all cylinders are fully retracted and machine is level.
2. Perform “Shut-Down Procedure” on page 4-3.
3. Open the engine cover.
4. Check level of hydraulic oil at the sight gauge (6) on the hydraulic tank (5). The
oil level should be visible in the gauge window.
5. If hydraulic oil is low, remove oil fill cap (7) from filler neck. Add hydraulic fluid to
bring oil up to the upper mark on the sight gauge.
6. Replace hydraulic oil fill cap.
7. Close and secure the engine cover.
8
OW1150
OW1030
OAH0070
5
7
6