JLG 266 LoPro Operator Manual - Manual (Page 77)

Section 5 - Attachments and Hitches
5-5 3126023
Sample Capacity Chart (AUS)
Note: This is a sample capacity chart only! DO NOT use this chart, use the one
located in your operator cab.
WARNING
TIP OVER HAZARD. All loads shown on rated capacity chart are based on
machine being operated within the parameters indicated on the appropriate load
chart; proper size tires being properly inflated; and the telehandler being in good
operating condition.
OAH1071
XXXXXXXXXX A
JLG XXX
P/N XXXXXX
P/N XXXXXX
P/N XXXXXX
P/N XXXXXX
P/N XXXXXX
P/N XXXXXX
10°
20°
30°
40°
50°
60°
0 1 2 3 4 M
0
1
2
3
4
5
6
-1
C
B
A
7
5
XXXXkg
XXXXkg
XXXXkg
XXXXkg
XXXkg
0°
XXX MM LOAD CENTER.
TRAVELLING (PICK & CARRY)
REQUIRES FIRM SURFACE WITH
LOAD ON FORKS
MAXIMUM XX M/S WALKING SPEED.
LIFTING (STATIONARY)
REQUIRES LEVEL AND FIRM SURFACE
WITH LOAD ON FORKS.
SPECIFICATIONS FOR SAFE USE
1. TYRE SIZES:
- XX XX PLY XX PSI / XX BAR.
- XX XX PLY XX PSI / XX BAR.
- XX XX PLY XX PSI / XX BAR.
2. IN-SERVICE WIND SPEED:
- XX M/S (XX KM/H).
3. GROUND CONDITIONS:
- FIRM SURFACES FOR BOTH LIFTING
AND TRAVELLING.
- SLOPE AND LOAD LISTED ABOVE FOR
BOTH CONFIGURATIONS.
4. STANDARD USED: (AS 1418.19-2007).
XXX mm MAX
X° MAX
X° MAX XXX mm MAX
X° MAX
XXX mm
MAX
LEVEL
LEVEL
BOOM FULLY RETRACTED.
Boom Extension
Indicator (arc)
Load zones indicate
the maximum weight
that may be safely lifted.
These numbers must match the
model/option number stamped
on the attachment ID Plate.
Boom Angle
This Capacity Chart may be
used with this model ONLY.
The model of your
telehandler is indicated on
the boom or chassis.
Model XXXX is used for
demonstration purposes only.
Pick and Carry
Information
Specifications
for Safe Use