Installation, 6 final drive sprocket, Removal – JLG 600SC_660SJC ANSI Service Manual User Manual
Page 134: Installation -30, Final drive sprocket -30, Removal -30, Final drive sprocket required tools - removal -30
SECTION 6 - UNDERCARRIAGE
6-30
– JLG Lift –
3120794
Installation
1.
Position track adjuster (2) in the undercarriage frame
of the machine.
2.
Install the washers and two bolts (1) that hold the
track adjuster to the undercarriage frame.
3.
Install the front idler and the recoil springs. Refer to
Disassembly and Assembly, "Front Idler and Recoil
Spring - Install" in this manual.
6.6
FINAL DRIVE SPROCKET
Removal
Separate the track assembly. Refer to Disassembly and
Assembly, "Track - Separate" in this manual.
NOTE: Adjust the height of Tooling (A) so that there is suffi-
cient clearance between the sprocket and the track
links for the removal of the sprocket.
1.
Lift the side of the machine. Install tooling (A) under
the frame, as shown.
Table 6-12. Final Drive Sprocket Required Tools -
Removal
Tool
Part #
Description
Qty.
A
8S-7640
Stand
2
8S-7611
Tube
2
8S-7615
Pin
2
B
138-7574
Link Bracket
1