JLG 120HX Operator Manual - Manual (Page 55)

SECTION 4 - MACHINE OPERATION
3120818 – JLG Lift – 4-5
4. Remove all load and allow engine to operate 3-5
minutes at LOW setting to permit reduction of
engine internal temperatures.
5. At Ground Controls, turn MASTER SWITCH to (cen-
ter) OFF. Position, the IGNITION switch (down) to
OFF.
6. Cover the Platform Control Console to protect
instruction placards, warning decals and operating
controls from hostile environment.
4.10 TIE DOWN AND LIFTING
When transporting machine, boom and snoot must be in
the stowed mode with turntable lock pin engaged and
machine securely tied down to truck or trailer deck. Four
tie down eyes are provided in the frame slab, one at each
corner of the machine.
If it becomes necessary to lift the machine using an over-
head or mobile crane, it is very important that the lifting
devices are attached only to the designated lifting eyes,
and that the turntable lock pin is engaged. See Figure 4-3,
Lifting Chart.
NOTE: Lifting eyes are provided at the front and rear in the
frame slab. Each of the four chains or slings used for
lifting machine must be adjusted individually so
machine remains level when elevated.