JLG 120HX Operator Manual - Manual (Page 63)

SECTION 5 - OPTIONAL EQUIPMENT
3120818 – JLG Lift – 5-1
SECTION 5. OPTIONAL EQUIPMENT
5.1 COLD START KIT (DIESEL ENGINE)
A cold weather start system for the diesel engine functions
automatically to provide starting fluid, as necessary, to the
engine during starting. A sensor switch mounted on the
engine will permit ether injection into the air intake when
the engine is cold. A temperature sensor will not permit
ether injection into a cold engine.
5.2 TRAVEL/MOTION ALARM
A 12-volt alarm horn, mounted on the turntable, provides
an audible warning when the machine is in the travel
(DRIVE) mode. It will function in FORWARD or REVERSE
to warn jobsite personnel the machine is traveling.
5.3 TILT ALARM
Senses when the machine is out of level in any direction
approximately 3 degrees and illuminates a warning light at
the platform control station and sounds the machine’s
horn, signaling the operator. A second switch mounted on
the machine senses when the machine is out of level 5
degrees and will cut out two speed drive when activated.
5.4 ROTATING BEACON
An amber or red rotating beacon may be installed on the
hood or platform, and can be controlled by a two position
toggle switch mounted on the platform control console.
When the switch is placed in the ON position, the light is
activated and provides a visual warning to the machine’s
operation.
5.5 HOSTILE ENVIRONMENT PACKAGE
The hostile environment package provides additional pro-
tection against the entry of dust, dirt, sand and other abra-
sive materials into the hydraulic system, control handles
and switches, cylinders, boom wire ropes and wear pads,
and the air inlet of the engine. The package is intended for
machines that will be exposed to painting, sandblasting or
other similar hostile conditions. The hostile environment
package includes boom wipers, cylinder bellows, heavy
duty reservoir breather, an engine air cleaner and control
console cover, as required.
5.6 110 VOLT GENERATOR
A 110 volt generator, mounted beside the engine, is belt
driven from the output shaft of the engine. This application
provides for a 110 volt receptacle at the ground control
and also at the platform. The lead from the ground control
and also at the platform. The lead from the ground control
to the platform is routed along the boom power track thus
eliminating the use of extension cords hanging freely from
the platform.