JLG 460SJ Operator Manual - Manual (Page 53)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121216 – JLG Lift – 3-15
NOTE: When boom is positioned above horizontal and any of the following switches, Drive
Speed/torque Select or Function Speed, are positioned to High, high function speeds
are automatically cut out and the machine continues to operate at a lower speed.
13. Main Lift/Swing Controller
The dual axis joystick is provided for main lift and swing.
Push forward to lift up, pull backward to lift down. Move
right to swing right, move left to swing left. Moving the joy-
stick activates switches to provide the functions selected.
Proportional control of these functions can be attained by
using the Function Speed knob.
NOTE: Main Lift, Swing, and Drive control levers are spring-loaded and will automatically
return to neutral (off) position when released.
NOTE: Main lift and swing functions may be selected in combination. The handle features a
round gate so that maximum speed is reduced when multiple functions are selected.
14. Footswitch (Not Shown)
This feature makes it necessary to depress the footswitch to
allow operation of the platform controls.
TO AVOID SERIOUS INJURY, DO NOT REMOVE, MODIFY OR DISABLE THE FOOTSWITCH
BY BLOCKING OR ANY OTHER MEANS.
FOOTSWITCH MUST BE ADJUSTED SO THAT FUNCTIONS WILL OPERATE WHEN PEDAL
IS APPROXIMATELY AT ITS CENTER OF TRAVEL. IF SWITCH OPERATES WITHIN LAST 1/
4" OF TRAVEL, TOP OR BOTTOM, IT SHOULD BE ADJUSTED.
NOTE: For engine starting, the footswitch must be in the released (up) position. Footswitch
must be actuated in order for the platform controls to function.
NOTE: These machines have a 7 second delay timer. If function has not been activated
within 7 seconds after depressing the footswitch, recycle footswitch.