JLG G12-55A AccuPlace Operator Manual - Manual (Page 45)

Section 3 - Controls and Indicators
3-11 3128447
Boom Functions - AccuPlace Mode
With machine in AccuPlace mode, a single motion of the joystick will move the
attachment along a vertical or horizontal path.
• Move the joystick back to lift vertically; move the joystick forward to lower
vertically; move the joystick right to extend horizontally; move the joystick left to
retract horizontally.
• The speed of boom functions depends upon the amount of joystick travel in the
corresponding direction. Increasing engine speed will also increase function
speed.
• Moving the joystick between quadrants will change the manner in which the
boom moves. Boom movement will not be strictly vertical or horizontal.
Attachment Functions
Attachment tilt is controlled by the roller switch (3).
• Push roller switch up to tilt attachment down; push roller switch down to tilt
attachment up.
WARNING
TIP OVER/CRUSH HAZARD. Rapid, jerky operation of controls will cause rapid,
jerky movement of the load. Such movements could cause the load to shift or fall
or could cause the machine to tip over.
OY1950