JLG 4017PS Platforms Operator Manual - Manual (Page 63)

Index
1 31200345
A
Additional Checks............................. 8-1
Approved Platforms.......................... 5-1
Auxiliary Power System.................... 6-2
Test ............................................. 8-1
B
Battery .............................................. 7-8
Boom Joystick .................................. 3-4
C
Capacity ........................................... 5-2
Chemical Hazards ............................ 1-9
Control Operation ............................. 4-3
Controls ............................................ 3-2
D
Decals .............................................. 2-3
Dimensions....................................... 9-2
E
Electrical Hazards ............................ 1-2
Emergency Lowering of Boom ......... 6-2
Emergency Operation ...................... 6-1
Emergency Procedures.................... 6-1
F
Fall Hazard ....................................... 1-8
Fuel Level......................................... 7-4
G
Gate.................................................. 2-8
General Maintenance ....................... 7-1
H
Hazard Classification System........... 1-1
I
Incident Notification .......................... 6-3
Indicator Panel ................................. 3-3
Installation ........................................ 5-3
L
Lanyard Anchorage Points................2-9
Lifting Personnel ...............................1-5
Load Falling Hazard..........................1-4
Lubrication and Maintenance............7-1
M
Minimum Approach Distance ............1-2
N
Normal Engine Operation .................4-2
O
Operational Check ............................2-7
Operator Maintenance Instructions...7-4
P
Performance .....................................9-1
Pinch Points and Crush Hazards ......1-6
Platform.............................................5-1
Platform Extension..........................2-10
Platform Operation............................4-2
Power/Emergency Stop Switch.........3-2
Pre-Operation Check and
Inspection..........................................2-1
Preparing Machine for Platform
Operation ..........................................4-1
S
Safety Decals....................................2-3
Safety Practices ................................1-1
Safety Signal Words .........................1-1
Service and Maintenance Schedule
1000 Hour....................................7-2
8 Hour..........................................7-2
Shut-Down Procedure.......................4-3
Specifications....................................9-1
Starting the Engine ...........................4-2
Supplemental Information .................9-3
Index