IOGear GHE225U Manual - Manual (Page 13)

11
If you purchased the enclosure model (GHE225U), please follow these instructions to install your 2.5" Hard
Disk Drive. OTHERWISE, PROCEED TO PAGE 16.
WARNING: Opening an ION™ Drive with a built-in Hard Drive (GHD225U40, GHD225U60, etc...) WILL
VOID YOUR WARRANTY. For assistance with your hard drive, please contact your IOGEAR Service
Support representative.
Hardware Installation:
Attention! Please take all proper Electro Static Discharge (ESD) precautions during the installation of your
new hardware. For further information on ESD please visit http://www.esda.org.
Installation of Hard Drive
Step 1.
Before you begin, please have a Phillips head
screw driver available.
Step 2.
Unscrew the buttom two screws of the ION™ Drive.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○