IOGear GHSW8242 Manual - Manual (Page 19)

19
OSD Setting
Use this screen to configure the GHSW8242 OSD settings.
1. Use the drop-down menu to select which display mode the GHSW8242 uses to display
information in the upper left corner of the screen. Options are as follows.
• Channel - This shows the source port number.
• Full - This shows the source port number and
source type. See Input Setting Menu, page 24 for
the list of source types.
• Off - There is no information shown.
2. Select the visibility of the OSD menu when it is invoked. Press the menu button to enter
the adjustment menu. Press the up/down button to select increase/decrease the value
then press the setup button to adjust. The value 100 shows a fully visible and opaque OSD
menu. The default value is 75.
Note: The Transparency value must be divisible by 5 (i.e., 5, 10, 15, 20...and so on).