2N Fixed line replacement with 2N EasyGate PRO - Quick Start, 1711 v1.01 - Manual

Outgoing call
· Suppose that the SIM card has been
inserted, the PIN entered or not required,
and EasyGate is registered to GSM
network – the GSM Network LED is
permanently on.
· Hook off the telephone, you can hear the
dial tone and the Line LED starts flashing.
· Dial the GSM subscriber number.
EasyGate receives tone dialing (DTMF) by
default. If your telephone transmits pulse
dialing only, program EasyGate to receive
pulse dialing. When you make a delay in
your
dialing longer than 5s
(programmable), the connection is
established.
· If the called subscriber is available, you
can hear the ringing tone. If not, you can
hear the busy tone or any of the GSM
provider’s messages.
· When the called subscriber answers the
call, the call is established. The Line LED
is permanently on during the call.
· Hang up to terminate the call. The Line
LED goes off. If the called subscriber is
the first to hang up, you can hear the
busy tone and hang up.
Incoming call
· An incoming call is signaled by ringing.
The Line LED flashes during ringing.
· Hook off the phone to establish the call.
The Line LED is permanently on during
the call.
· For call termination see the Outgoing call
section.
Fax and data connection
(only fax models)
EasyGate with fax converter has ability to
manage fax messages using analogue fax
Group 3 and data connection using analog
modem connected to telephone line. The
fax or data service must be registered with
your GSM operator.
· Outgoing FAX call or Data connection
Before destination number dial code
*01* for fax call or *02* for data call.
When connected device generates calling
tone, this preset is not necessary.
· Incoming FAX call or data connection
It is recommended to activate separate
fax number on your SIM card –
multinumbering
scheme. Fax
messages and data connection should be
routed to appropriate number.
If the fax or data number is not
activated, the call from analogue network
is not detected as fax or data call and is
routed via the analogue channel of GSM
network, the connection can´t be
established. In this case it is possible to
set fax engine in the gateway to receive
the next call as fax or data call. This
setting can be done permanent - see the
manual on CD-ROM. This function is not
guaranteed by all operators.
Configuration over USB
· For PC configuration of EasyGate is
necessary to install PCManager UNI.
Connect EasyGate to PC using USB cable.
· Virtual serial port(USB serial port FTDI) is
created immediately after linking PC and
EasyGate. This port is used by
PCManager
to communicate with
EasyGate. When the port isn’t activated
automatically use driver on CD
· The COM port number of virtual serial
port has to be set in PCManager.
· Detailed description is in the product
manual on CD-ROM.
In the GSM network, GPRS data transfer is suspended during voice calls
and do not continue until the voice call is finished.
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyGate PRO product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our
website www.2n.cz for the Declaration of conformity.
© 2011, 2N TELEKOMUNIKACE a.s. – Prague, LH 1711, v.1.01