2N Fixed line replacement with 2N EasyGate PRO UMTS - Quick Start, 2018 v1.00 - Manual

Outgoing call
· Suppose that the SIM card has been
inserted, the PIN entered or not required,
and EasyGate is registered to the network
– the LED Mobile network is permanently
on.
· Hook off the telephone, you can hear the
dial tone and the Line LED starts flashing.
· Dial the subscriber number. EasyGate
receives tone dialing (DTMF) by default.
If your telephone transmits pulse dialing
only, program EasyGate to receive pulse
dialing. When you make a delay in your
dialing longer than 5s (programmable),
the connection is established.
· If the called subscriber is available, you
can hear the ringing tone. If not, you can
hear the busy tone or any of the mobile
network provider’s messages.
· When the called subscriber answers the
call, the call is established. The Line LED
is permanently on during the call.
· Hang up to terminate the call. The Line
LED goes off. If the called subscriber is
the first to hang up, you can hear the
busy tone, you have to hang up.
Incoming call
· An incoming call is signaled by ringing.
The Line LED flashes during ringing.
· Hook off the phone to establish the call.
The Line LED is permanently on during
the call.
· For call termination see the Outgoing call
section.
Configuration over USB
· For PC configuration of EasyGate is
necessary to install PCManager UNI.
Connect EasyGate to PC using USB cable.
· Virtual serial port(USB serial port FTDI) is
created immediately after linking PC and
EasyGate. This port is used by
PCManager
to communicate with
EasyGate. When the port isn’t activated
automatically use driver on CD
· The COM port number of virtual serial
port has to be set in PCManager.
· Detailed description is in the product
manual on CD-ROM.
Data connection over USB
· Easy Gate can be used for high speed
connection to internet (up to 3,6 Mbps
download).
· You have to install USB drivers for UMTS
module. Drivers are on CD-ROM. You
have to select 32 bit drivers or 64 bit
drivers according to your system.
· For internet connection you must set the
APN. Use PCManager, select GSM&SIM
menu and set APN to the APN name of
your mobile internet provider.
· You have to set phone connection in your
PC using Network connection setting.
Select modem ‘SimTech HS-USB Modem
9000’ for this connection. Set the
connection
parameters (Username,
Password, Dial number) according to
information from your mobile provider
(obviously Username ‘internet’, Keyword
is empty an Dial number *99***1#).
· Finally use button ‘Dial’ to establish
connection to internet.
In the GSM network data transfer is suspended during voice calls and do
not continue until the voice call is finished. UMTS network is able to
transfer data concurently with voice.
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® EasyGate PRO UMTS product is in compliance with
the essential requirements and other relevant provisions of Directive 1999/5/EC. Refer to the CD-ROM or our
website www.2n.cz for the Declaration of conformity.
© 2013, 2N TELEKOMUNIKACE a.s. – Prague, LH 2018, v.1.00