2N Home intercom 2N Helios - Manual - display installation - Manual

- 1 -
2ENTRY Helios display
Order no. 9135240E
Description
Built-in set 2ENTRY Helios display will allow you to expand any kind of the base module of
2ENTRY Helios door communicator with a graphical display, displaying a phone list. Maximum
capacity of the phone list is 1000 items. Full graphical display will allow you to display names,
logos, or flat numbers. For searching the list of names, designated buttons are used with the
name tags at the base module of 2ENTRY Helios. Where the base module has a built-in
keypad, this can be used for searching for fast items finding in multiple modes. Telephone list
can be programmed from the PC using the USB port.
Warning!
Before displaying the connection via the USB port of PC, it is necessary to disconnect display
from base PCB of the door phone. If not done, it can damage the display, door phone PCB
or connected PC!
Telephone list transfer
Before transferring to the display, it is necessary to create a file containing the phone list. The
file can be created by the web application situated on the manufacturer’s site www.2n.cz . With
the same application you can also scroll through or edit all ready existing phone lists.
After you successfully create the file, connect display to the USB port of the PC. With the first
connection to the PC, an automatic pop up will inform you that New Hardware was found. Insert
the provided CD. In the dialog window select Install from a list or specific location
(Advanced). Click Next. In the next wizard window select the way to the file Driver on supplied
CD and then click Next.
After finishing the installation click Finish. The second part of installation will run
automatically. Continue in the same way as with first installation.