ACU-RITE MILLPWRG2 - Manual (Page 200)

182 9 Setup
9.1 Set
u
p
To set the Z axis Travel Limits:
 ARROW down to the TRAVEL LIMITS Z Axis field.
 Move the quill by pressing the Move Table soft key, then use the
Move Z Up
and Move Z down soft keys. The axis can also be manually
moved with the hand lever, or wheel.
 Move the quill up to where the top of the quill travel limit stop is to
be set with the Move Z Up soft key, or done manually. With the quill
set in the required location, press the Set Top softkey.
 Move the quill down to where the bottom travel limit stop is to be
set using the Move Z Down soft key, or done manually. With the quill
set in the required location, press the Set Bottom softkey.
 Press the Exit soft key to exit Move Table, and accept the Z Axes
limit stop locations.
 Press the USE key to accept all the settings in Job Setup.
The Z axis travel field will now update to show the
maximum allowable travel distance between the upper
and lower limit stops.
If a power cycle occurs while in the Job Setup dialogue, all
travel limits set will be lost.