AiM GPS05 Module - Manual (Page 17)

GPS05 Module
User manual
Release 1.01
4 0
4.4.2 – Setting GPS Laptimer
Once MyChron4 is correctly configured it is necessary to go on the track to set lap
and split positions giving correct instructions to the GPS05 Module.
This allows it to get beacons.
Warning: this operation is required the first time entering the track and only
once for each track.
To set lap/splits position switch MyChron4 on and press ON/View button until “G.P.S.
Data” page - shown below - appears:
Note
: it may occur that at first the page shows “Initializing” in spite of “OK to begin
settings”; just wait a few moments and the correct message appears.
To correctly set lap and split positions it is suggested to run the first track lap more
slowly so to have enough time to enter the desired points of the track.
Press OK button to begin settings (or VIEW button to exit).
If the logger is configured not to sample split times this window appears:
To set Start/Finish line
press OK button once reached the desired position on the
track and Start/finish line position is saved (press VIEW button to exit).
www.aim-sportline.com 16