AiM GPS05 Module - Manual (Page 9)

GPS05 Module
User manual
Release 1.01
3 6
2.5.2 – How to set GPS beacons
Here follow the steps to set start/finish line and splits position of GPS05 Module:
• ensure
GPS05 Module
is correctly connected to MXL
• press “MENU” button on MXL keyboard.
• the system shows a menu with backlight and GPS options
• select “Set GPS beacon” using “>>/<<” buttons
• press “OK” button
MXL
asks to set start/finish line
Reach the point to be considered as start/finish line and press “OK” button
Start/finish line position is saved.
Once start/finish line is set, if the system is configured to capture splits, the page
shown below appears; reach the point of the track to be considered as split and
press “OK” button.
Once the configuration is over, the system shows start page and can record times.
“GOOD TRK”, circled in the figure below, confirms that the track has been recognised
lap and split times can be recorded.
To cancel the proceeding switch MXL off and then on again.
Warning: in case of low signal the system could ask again for beacon settings.
It is moreover recommended not to set lap or split markers under bridges or
near to obstacles.
www.aim-sportline.com 8