AirLive AirMax5X - Manual (Page 37)

4. Web Management: Operation Mode Settings
AirLive AirMax5X User’s Manual
31
4.2.1.7 Transmit Power
Operation Mode -> Setup -> Transmit Power
You can adjust the transmit output power of the AirMax5X’s radio from 12 to 27dBm. The
higher the output power, the more distance AirMax5X can deliver. However, it is advised
that you use just enough output power so it will not create excessive interference for the
environment. Also, using too much power at close distance can create serious performance
drop due to signal distortion.
4.2.1.8 Transmit Distance
This area is to set the transmit distance. Longer distance between AirMax5X and Client
have required longer ack time out. But AirMax5X users does not need to calualte the ACK
time out, users just need to put the maximum distance between AP and Client. In real
application, we suggest that users and add 2 more Km for transmit distance. For example, if
the distance between AP and Client is 10Km , it is better to set the transmit distance to
12Km
4.2.1.9 DFS Control
DFS(dynamic frequency selection) is required to operate WiFi devices in 5GHz. Before you
disable the DFS , please make sure your country’s regulatory is not violated.
4.2.1.10 Advanced Setting
Operation Mode -> Setup -> Advance Settings
This page includes all the wireless settings that change the RF behaviors of AirMax5X. It is
important to read through this section before attempting to make changes. If you are not
familiar with those setting, we suggest you use the default setting.
RTS/CTS
Threshold Determines the packet size of a transmission and, through
the use of an AP, helps control traffic flow. The range is
0-2346 bytes.
Beacon Interval Beacons are the packets sending by Access point to
synchronize the wireless network. The beacon interval is the
time interval between beacons sending by this unit in AP or
AP+WDS operation. The default and recommended beacon
interval is 100 milliseconds.