AirLive BU-3025 - Manual (Page 51)

5. Appendix
AirLive BU-3025 Manual 45
The username and
password for the first
time or after factory
default reset Username = admin and Password = airlive.
Note that it’s all case sensitivity.
Forgot the username
and password To restore factory default, please follow the steps:
1. Unplug the power jack to turn off the power of the
camera.
2. Insert a pin into the reset hole as circled with red in
the below figures. Sense a button and keep it pressed
until instructed to release.
3. Plug in the power jack to turn on device, and the
status LED will be quick flashing after a few minutes.
4. Release the button (remove the pin from the reset
hole). The camera should now be back to factory
default.
5. Default IP address is 192.168.1.100.
Username/Password is admin/airlive.
Forgot the IP address
of the device. Check IP address of device by using the IP Wizard II
program or by UPnP discovery.
IP Wizard II program
cannot find the device. • Re-power the device if cannot find the unit within 1
minutes.
• Do not connect device over a router. IP Wizard II
program cannot detect device over a router.
• If IP address is not assigned to the PC which running
IP Wizard II program, then IP Wizard II program cannot
find device. Make sure that IP address is assigned to
the PC properly.
• Antivirus software on the PC might interfere with the
setup program. Disable the firewall of the antivirus
software during setting up this device.
• Check the firewall setting of your PC or Notebook.
Internet Explorer does
not seem to work well
with the device Make sure that your Internet Explorer is version 6.0 or
later. If you are experiencing problems, try upgrading
to the latest version of Microsoft’s Internet Explorer from
the Microsoft webpage.
IP Wizard II program
fails to save the
network parameters.
Network may have trouble. Confirm the parameters
and connections of the device.