AirLive WP-203G - Manual (Page 87)

8.4.2 Wireless Setting
If you want to use the print server through wireless LAN, please set up the
print server through Ethernet first and make sure your wireless LAN
setting is correct. After setting the wireless LAN, unplug the Ethernet
cable and restart the print server, then you can start to use the print server
through wireless LAN. If the wireless configuration does not work, please
plug the Ethernet cable again, restart the print server and configure the
print server through Ethernet until the wireless LAN settings are correct.
You can enable/disable the wireless function and set parameters that are
used for the wireless stations to connect to this print server from here.
The parameters include “Function”, “Mode”, “ESSID” and “Channel
Number”. You can manually set the parameters of wireless LAN in this
page or use the “Site Survey” function to automatically search for an
available access point and associate with it.
Function: You can select “Auto”, Enable” or “Disable” to manually
configure the wireless function.
y Auto – “Auto” is the default setting of the print server. At this mode, the
print server will automatically decide to enable or disable the wireless
function. When the print server starts up, it will auto-detect if the LAN
port is connected to an active network by an Ethernet cable. If this is the
82