AirLive WP-203G - Manual (Page 88)

case, the print server will run in Ethernet mode. If the print server is not
connected to an active network by Ethernet cable, the print server will run
in wireless LAN mode.
Users can plug the Ethernet cable to the print server at the first, after
configuring the print server features and wireless settings; they can unplug
the Ethernet cable to enable the wireless connection. It makes the
configuration much easier without creating the wireless connection in
advance.
y Enable – Enable wireless function only, the print server’s wireless LAN
will be always enabled and Ethernet will be always disabled.
y Disable – Disable the wireless function, the print server’s wireless LAN
will be always disabled and Ethernet will be always enabled.
Mode is the operation mode of wireless station. You can choose ether “Ad
Hoc” or “Infrastructure” mode. If you do not have any access point and
want to use peer-to-peer connection, you have to choose “Ad Hoc” mode.
If you have an access point as the wireless LAN infrastructure, you have
to choose “Infrastructure” mode.
ESSID is the unique name identified by in a wireless LAN. The ID
prevents the unintentional merging of two co-located WLANs. Please
make sure that the ESSID of all stations and access points in the same
WLAN network are the same.
Channel Number is the channel number of your wireless LAN. Please
make sure that the channel number of all stations and access points in the
same WLAN network are the same.
83