Anchor NAVI-TRAC 40 WIDE HIP-END - Manual (Page 8)

LAYOUT END MODULE COMPONENTS
CONSTRUCT FIRST BEAM
NOTE: ON END MODULES, EAVE FIT-
TINGS FOR BOTH EAVES AND RAF-
TERS ARE RIGID SLIP JOINTS.
HOOK THE END RAFTER TOP FITTING ONTO THE
PEAK/RIDGE WELDMENT. THEN SLIDE THE END
RAFTER ONTO THE BOTTOM OF THE END FITTING
AND BOLT.
HEAVY DUTY NAVI-
TRAC FRAME LIFTS
NOTE: ONLY FIXED-BASE UPRIGHTS
ARE TO BE USED IN END MODULES.
HINGED BASE UPRIGHTS ARE FOR
MIDDLE BEAMS ONLY AND COULD
CAUSE COLLAPSE DURING
INSTALLATION IF USED
IN AN END MODULE.
UPRIGHT
BRACES
END
FITTINGS
END
FITTINGS
CROSS-CABLE
BRACE, RIDGE
BRACE, RIDGE
HIP LOWER SPLICES HIP UPPER SPLICES
OPTION: IF YOU ARE ASSEMBLING A SQUARE UNIT,
THE TRAILING END INTERMEDIATE RAFTER CAN BE
ATTACHED TO THE PEAK NOW TO AVOID LATER CON-
NECTING IT FROM A LADDER.
INSTALL RIDGE
BRACE WHILE BEAM
IS FLAT ON THE
GROUND
CROSS-CABLE IS
INSTALLED DURING
INSTALLATION ONLY.
AS BEAM IS PIVOTED TO
VERTICAL, THE EAVE BARS
ACT AS COUNTER-WEIGHTS TO
MAKE THE LIFTING EASIER.
FOR EASIEST ASSEMBLY,
MAKE CONNECTIONS IN
ORDER SHOWN
1
3
4
2
6
5
7
FIXED-BASE
UPRIGHTS
7
8