Anchor NAVI-TRAC 40 WIDE HIP-END - Manual (Page 9)

9
1
3
4
2
6
5
7
INSTALL DROP-IN HIPS AND HIP BRACES IN THE ORDER
SHOWN. HINT: TO ALIGN HIP BRACES , LIFT CENTER
OF HIP BAR, THEN DROP THE HIP BRACE CONNEC-
TORS CLEANLY INTO FITTINGS.
IF YOU ARE CONSTRUCTING AN EXTENDED RECTANGULAR TENT, INSTALL FABRIC NOW. IF YOU
ARE CONSTRUCTING A SQUARE TENT, PROCEED TO THE NEXT STEP.
USE LIFTING CRADLES TO MAKE HIP-PEAK
CONNECTIONS. USE LADDER AS NEEDED TO
SECURE PINS WITH LANYARDS
PRE-ASSEMBLING THE HIP MEMBER
BOLT UPPER END FITTING INTO TOP END
BOLT UPPER END FITTING INTO BOTTOM END
SPLICE TOP TO BOTTOM HIP SECTIONS
AND SECURE WITH GRAVITY PIN
COMPLETING HIP END TOP FRAME
ASSEMBLING HIP END TOP FRAME
HIP END
FITTINGS
HIP END
FITTINGS
UPRIGHT
BRACES
HIP BRACES
HIP LOWER SPLICES HIP UPPER SPLICES
FOR MOST EASE, MAKE
CONNECTIONS IN ORDER
SHOWN.
FIXED-BASE UPRIGHTS
(FOR END MODULES)
HEAVY-DUTY
NAVI-TRAC
FRAME LIFTS
1
DO NOT OVER TIGHTEN END FITTINGS,
ALLOW FOR SWIVEL ACTION
ATTACH LANYARDS WITH SAME
BOLTS AS END FITTINGS
7
8 6
2
5
3
9
11
4 10
6
12