APG FLE Series user manual - Manual (Page 6)

FLE Series Rev. A3, 10/08
6
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
• Installation
- Location -
Do not locate the FLE series sensor near inlets/outlets.
If there is surface wave action, then use a time-delay relay or stilling tube. If a
stilling tube is used, drill vent holes in the tube and use a centering spacer on
the bottom of the stem to assure the float has free travel inside the tube.
Wave action may cause switch to chatter. Use a stilling tube or time-delay
relay to prevent switch chatter.
- Mounting -
The FLE can be mounted up to 30 0 from vertical.
1. Flange Mounting
Provide the compatible mating flange on the tank and install using a suitable
gasket.
2. Plug Mounting
Provide the compatible female boss on the tank and install the FLE with a
suitable gasket, O-ring, or thread tape.