Autoquip TORKLIFT T2 DOUBLE PANTOGRAPH - Manual (Page 16)

16
Verify installation area is clean before starting. Check mounting surface of pit floor with a level or straight
edge. If floor is not level, add shims or grout under entire perimeter of base to achieve a level and flat base
installation. A level base is essential for proper wheel tracking and smooth lift operation.
Prevent serious injury or death.
Depending on model, weight of lift ranges from 1500 – 4450 lbs.
Use a properly rated lifting device to move and install lift.
Lower lift into pit and check for proper height. Lift must be solid and flush with pit angle framing (D). If
needed, shim to desired height. DO NOT “spot” shim. Shim along full length of frame. This will prevent
frame from sagging under load.
Prevent serious injury or death.
Electrical service installation must be
performed by a
licensed electrician and conform to all local and national
electrical codes.
NOTE: For larger horsepower motors, consult factory.
Temporarily connect electrical service and hydraulic hoses.
Fill hydraulic reservoir with proper type and volume of fluid.
Press “UP button and raise lift one foot.
Press “DOWN” button to fully lower lift. Continue to hold down
button for 60 seconds. Repeat procedure five to seven times to
bleed air out of hydraulic system.
Raise and lower lift as needed to make positioning adjustments.
Adjust platform to a clearance of 1” minimum around perimeter
between platform and pit angle.
NEVER go under a raised lift platform until load is removed and
lift is securely blocked in raised position with maintenance
devices.
See "Maintenance Device" section of this manual.