Autoquip TORKLIFT T2 DOUBLE PANTOGRAPH - Manual (Page 9)

9
3. SAFETY
3.1 Safety Signal Words
This Owner’s Manual covers T2-T3 Torklift produced by Autoquip. Before installing, operating or
servicing lift, you must read, understand and follow the instructions and safety warnings in this
manual. Your lift may not be equipped with some optional equipment shown in this manual.
The safety information in this manual is denoted by the safety alert symbol:
The level of risk is indicated by the following signal words.
DANGER – Indicates a hazardous situation, which, if not avoided, will
result in death or serious injury.
WARNING – Indicates a hazardous situation, which, if not avoided, could
result in death or serious injury.
CAUTION – Indicates a hazardous situation, which, if not avoided, could
result in minor or moderate injury.
NOTICE – Indicates a situation that could result in damage to the lift or other
property.
3.2 Installation
Do not install lift in a pit unless pit has a bevel toe guard or other
approved toe protection. A shear point can exist which can cause
severe foot injury.
Lift platforms traveling below floor levels may create a toe hazard as load
passes top edge of pit. This may require guarding in accordance with
Federal Regulations. Guarding must be installed prior to operating lift.
Prevent serious injury or death.
Depending on model, weight of lift ranges from 1500 – 4450 lbs.
Use a properly rated lifting device to move and install lift.