Lift blocking instructions, Warning, Danger – Autoquip SERIES 35 LOW PROFILE User Manual

Page 16

Advertising
background image


LIFT BLOCKING INSTRUCTIONS

WARNING !

Only authorized personnel should perform inspection or
maintenance and service procedures. Unauthorized personnel
attempting these procedures do so at the risk of personal injury
or death.

DANGER !

Failure to properly adhere to lift blocking procedures is to risk
the sudden and uncontrolled descent of the lift during
maintenance or inspection. A falling lift can cause severe injury
or death.

This procedure describes the only factory-approved method of working under a lift.
Follow these instructions EVERY time you plan to reach or crawl beneath the lift to
perform service or maintenance – no matter how momentary that might be.

If the factory-provided maintenance devices are damaged or missing, stop immediately
and consult the factory for assistance. The manufacturer is not liable for your failure to
use the approved maintenance devices and procedures that have been provided.

1. All loads must be removed from the lift prior to engaging the maintenance

devices. These devices are designed to support an unloaded lift only. Failure to
remove the load from the lift prior to blocking could cause the failure of the
maintenance devices and allow the lift to fall unexpectedly. This can result in
personal injury or death, or permanent damage to the maintenance devices
and/or the lift.


2. Raise the lift to its fully raised position. If you do not, the maintenance devices

may not be able to be placed properly in their designed blocking position.

3. Locate all hinged maintenance locks permanently welded outside the base frame

on the roller end of the lift base legs. Both locks must be flipped over and resting
inside the base frame and thus in the roller path of the lift (See Figure 9).

4. Lower the lift platform until the leg rollers make contact with both maintenance

locks. Re-check to ensure that both devices are fully and properly engaged with
the leg rollers. If both left and right maintenance locks are not fully engaged the
lift could fall unexpectedly, resulting in permanent damage to the devices or the
lift.

16

Advertising