BAND-IT S35099 Automatic Air Tool - Manual (Page 3)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # S41067 rev. H
© Copyright
BAND-IT-IDEX, Inc. 2010
All rights reserved
www.BAND-IT-IDEX.com
Page 3 of 34
S35099
Automatic Air Tool
Refer to website for warranty information:
http://www.band-it-idex.com/warranty.html
SAFETY RULES:
When applying clamps, care should be taken to make certain that fingers are not in the way of the
clamp being applied. Tensioning the clamp can be stopped immediately by releasing the foot pedal.
Detailed instructions are in this manual and the operator is advised to read it and become familiar
with operating the tool.
IMPORTANT: When clamping a hose end, remember that a tighter clamp keeps the fitting more
secure, but excess tension could damage the hose. Fitting stem must have prominent barbs for
proper retention inside the hose, but must not be sharp to prevent cutting into the hose. Hose, fitting
and clamp must be compatible with each other and the environment used in. If in doubt, consult the
hose or fitting manufacturer or call BAND-IT.
Clamping objects other than hose requires similar precautions.
CAUTION:
Improperly tightened clamps may result in dangerous hose assemblies, which could
cause injuries or property damage.
CAUTION:
Abuse or use of a hose outside the manufacturers recommended conditions may cause it
to quickly deteriorate and become a safety hazard. This could result in serious injury or property
damage. Inspect and test hose assemblies frequently.
Warranty and
Safety Information