BAND-IT S75099 Pneumatic Junior Clamp Application Tool - Manual (Page 19)

Document# P36687 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver,
CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
19
S75099 Pneumatic
Junior Clamp
Application Tool
Replacement
Service Parts
S45799 Gripper and Spring Kit Installation Instructions
Shear Hook and Handle Assembly
Gripper
Gripper
Spring
Gripper Pin
and Access
Hole
Set
Screw
1. Extend the tool piston fully
forward. The gripper pin should
be visible through the access
hole.
2. Disconnect air from the tool.
3. Loosen set screw and
disconnect gripper spring.
4. Tap out gripper pin, remove old
gripper and replace with new.
5. Connect new spring between
gripper and spring pin.
Cut-Off
Handle
S11589
Shear
Hook
J00587
Handle
Pin
S52987
Shear
Hook Pin
J90887
Set
Screws
J64887
To remove handle, loosen the
2 set screws and tap out pin.