BAND-IT S75099 Pneumatic Junior Clamp Application Tool - Manual (Page 3)

Document# P36687 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver,
CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
3
S75099 Pneumatic
Junior Clamp
Application Tool
For Warranty information visit the following URL
www.BAND-IT-IDEX.com/Warranty.html
Use of the S75099 without proper filtration and lubrication will void the warranty.
See section on air system requirements for details.
Safety Guidelines:
•
Read this manual and become familiar with the tool before installing any clamps.
•
Protective eyewear should be worn when connecting and disconnecting the tool to
compressed air sources and during operation.
•
Wear appropriate gloves for handling steel while operating this tool, applying steel
clamps and removing the scrap clamp tail.
•
Tool should be firmly mounted to an adequate support surface.
•
Clamp tensioning or clamp tail retrieval can be immediately stopped by releasing
pressure from the foot pedal.
•
When applying clamps, care should be taken to insure fingers and loose clothing are
not in contact with the clamp being applied.
•
Never attempt to clamp objects which have the potential to burst, shatter or
otherwise cause bodily harm.
•
Disconnect air supply prior to maintenance and disassembly of tool components.
•
Liquids such as soaps and solvents should never be put directly into the airlines or
allowed to circulate through the tool.
•
Additional Safety messages are included as part of the tool operation and clamp
installation sections.
Warranty
and Safety