Carbolite nanodac - Manual (Page 45)

nanodac™
43
MC27 –EN–1.04
4.4.12 EtherNet/IP display mode
This display mode appears only if enabled in Instrument.Display configuration and is used to display the
input and output parameters assigned to the Client and Server input and output tables. Parameters
which have been configured with descriptors are identified by these descriptors instead of their ‘opc’
names (shown below).
Figure 1.4.13a Typical EtherNet/IP display
EtherNet/IP Client
EtherNet/IP Client
EtherNet/IP Client
Virtual Channel.1.Main.Input1
Virtual Channel.2.Main.Input1
Loop.1.Setpoint.SP1
Loop.1.Setpoint.SP2
Loop.2.Setpoint.SP1
Loop.1.Setpoint.SP2
11.1
-19.1
123.0
132.0
246.2
111.11
Virtual Channel.1.Main.Input1
Virtual Channel.2.Main.Input1
Loop.1.Setpoint.SP1
Loop.1.Setpoint.SP2
Loop.2.Setpoint.SP1
Loop.1.Setpoint.SP2
17.3
-12.9
123.0
132.0
246.2
111.11
123.123.123.223 : Point2Point : 1000ms
Implicit I/O
123.123.123.222
Client (IO)
Explicit 1
No Connection
Explicit 2
No Connection
IO Server Configuration
IO Server Identity
Mode Client (IO)
Input Instance
Size (Bytes)
100
100
Server Address
Priotity
RPI (ms)
Connection Type
123.123.123.
223
Scheduled
1000
Point2Point
Output Instance
Size (Bytes)
112
100
Reset No
Vendor Number
Device Type
Product Code
Revision
Status Word
Serial number
Product Name
45
0
E780
n.nn
0
8D01904C
Nano
Inputs
Outputs
Server IP
address,
Connection
type,
RPI
IP address
and mode of
operation for
this unit
See ‘Explicit’
data below
The list of parameters can be scrolled through
using the up/down arrows.
Items with green arrows can be edited if the user is
logged in with the correct access level.
Data depends on the slave